Another day turns to shit, figured I put some fluid I had here in, filled the brake reserve T figured I see if any gravity bleeding would work, tried to open the closest on, passenger front & I could NOT get the bleeder open, will pull the wheel another day I don't want to strip that thing!
So I'm putting in the power steering fluid & put some in, still low, put a little more in & it's over filled an inch or so, I don't know how much will actually go over to the box, will wait & see.
So I started the touch ups, mixed a tiny bit of putty for the big chips.
Now I'm trying to mix a tiny bit of paint, used an eye dropper, went to get a tad more & dropped it into the paint can, well this dumb ass sticks his hand in with no glove on, me be blue now!
Cept for the one deep chip on the door that seemed to go ok, I'm in the 5 foot rule area.
So in between I figure I'll do the trim rings & lugs.
Well trim rings would not cooperate, I could not get another on any wheel, now the first on that's on I did by hand, but it never seemed to lock in.
The rest would just keep popping back & forth, so to check that I'm not going completely nuts I pulled out an old one, right on with the rubber mallet, all the way in & tight!
Came the closest on the left rear, but if I try & get that last part flat it just pops the whole thing out, so I go back to the one that was on, tapped on the part that was out a little & the whole thing popped off!
First bump & these would be rolling down the highway!
So I put em on the bench to compare, new are deeper & have much bigger locking tabs, gonna go search them again & see what the other options are?
This shit is starting to get to me!
So I cleaned the blue off the other 3 wheels & called it a day!