69 Barracuda FB. The next evolution

[gomopar440]

I opened up the floor a bit more in the pass side rear seat footwell area. Also cut off the middle of the exhaust at the straight part, right behind the trans pan, to get it out of the way. The retaining brace for the E-brake cable under the driver floor was then cut off the piece of floor I cut out yesterday.

After resting my back, I'll go out and wire wheel the areas where the subframe connectors land.

 

[gomopar440]

The center of the driver side floor was so distorted that I decided to remove the rest of it on that side. The areas the subframe landed got wire wheeled clean next. When I set the connector in place, there were still a few nubs that need to get cut off so it could sit flush with the under side of the floor around the forward end of the rear subframe. The connector is now strapped to a couple 4x4's to hold it in place for welding.

The plan is to weld it in tomorrow when my back is, hopefully, feeling better.