small block 727

[charger0740]

I am still thiking over the idea of putting that 98' 360 into my 73' charger (which has a 318 and a 904) i was wondering would a small block 727 bolt right up to the 360 and if so would i then have to shorten my drive shaft?

 

[71ChargerRT]

Yes it will, but you will need a convertor, and the driveshaft will have to be shortened

 

[GoodysgotaCuda]

yep, make sure you have the proper flexplate or balanced converter for the 360...

 

[Mark Nixon]

What are you planning on using for fuel delivery?

Keep in mind that the 360 Magnum uses a lighter weighting.
That weighting is sometimes on the torque convertor, or it can be on the stock Magnum flex plate, it's a 50/50 deal.

Charger0740, Too bad I didn't know you were looking for '73-'74 Charger parts about a month ago, there was a '73 in a self serve J/Y that had rustfree 1/4s, a perfect trunk floor and a nice driver's fender.
I'm certain it's mashered and gone by now.

Mark.

 

[71dusterman]

Anyone have anyone 3rd gen. charger parts for sale.

I have a kind of green-gold interior for sale. Original in good shape high back bench with fold down center and rear seat and all the side panels for the front, doors and rear area. Came out of a 74 Charger donor car of my sons.