square hole punch?

[69.5CUDA]

anyone know where i can get a relitively cheep square hole punch for punching out about 1inch sqaure holes(1x1.5 would be even better)....i need one for building the console for the lloyd...going to pick up a round hole punch set from harbor frieght for the round stuff( head lights, ignition, hazzards, heater controls)..all holes will be in thin aluminum....i need a square punch for the wipers, fogs, markers, and windows....

otherwise im looking at alot of dremel time

 

[gomopar440]

Got a picture or drawing*wink wink* of what you're trying to do with it?

 

[dodgechargerfan]

Eastwood at $65 is actually very cheap.
http://www.eastwoodco.com/jump.jsp?itemID=1491&itemType=PRODUCT

I found the same thing listed for over $200 on other sites.

There's a couple of used ones on eBay going for around $25 plus hsipping right now, but they are auctions...

 

[69.5CUDA]

why the hell didnt i think to look on ebay :bonk:

gomo gimmy a day or so to make a "mockup" on plexiglass or cardboard....lets just say i found a ring for the ignition switch and a headlight switch/dimmer that i HAD TO HAVE!!!! along with some other rather nice switches....and ive got a few LARGE nice pieces of old school stamped aluminum(id say diner type the almost wrinckle finish)