Search results

I have a lot of friends in the medical profession that have said if not for the vaccine mandate threatening their lively hood and info they know, they would not have gotten the vaccine. Dave, you and I have met several times over the years thru Moparnuts and and some of the big meets. I...

This is the end of my comments on this matter. Research Dr Paul Alexander and his stance on the vaccines and then make your choice about mandates. I'm out of this. Let true science make the decisions not big Pharma.

All this could have been resolved if our pussy of a Prime Minister would actually talk to the people of Canada. His conversations with other leaders in the world , he says to talk issues thru. He doesn't listen to his own words. He is heavily invested in Physor and Mederna and that's why he has...

You could probably fab a jig to hold the shape you want while getting everything set up and sprayed.

From the markings on the build sheet, it has been moved to it's current location.

EV clean makes more environmental waste than an ICE vehicle in the same time frame. They also cost way more in maintenance that an ICE does because of the cost to replace the batteries and then the recycling cost is astounding. I talked to a friend who had a friend that had an EV car that needed...

Sorry, just not my cup of tea. I guess I just like them slightly modified from original. That one has taken it more to the stratosphere.

Hope any members in the Southern BC are safe from all the flooding and mud slides that are cutting off huge swaths of the BC highways and towns. The whole town of Merrit has come under an evacuation order.

As Jass implied, if the elbow plug doesn't have a good grating feel when you slide it on the sensor plug, that is where I think you are loosing the connection. I would try to get a new one and splice it into the wire so you get a good solid connection no matter how much you twist and turn it...

BBB. The problem with your tv stopping is rohos solder. I had a similar issue with one and found the solution was to take the offending circuit board out and and put it in a 380* toaster oven for 10 minutes. Re-installed the board and my son has been using a 47" tv ever since. Been going strong...

I found a set of halogen housings for mine at a swap meet.

I hear you about customer service or the lack thereof. I ordered a boat bow and cabin cover for my boat, the supplier did not have the pattern for my boat so requested that I send him the old cover to make the new one with. I sent him the old cover and a couple weeks later received the new...

Happy to see you alive and well. Been a while since you were last on. Good luck with your find.

I would tack instead of epoxy. A tack is less likely to let go and cleaning an oily area is not a sure thing for good adhesion.

If you can't get the ball joint to take grease there is a needle attachment for a grease gun that you poke into the rubber boot to add the amount of grease you require. In the future you can locate the same hole and add grease again for regular maintenance.

Recharge and you will probably be fine. You could do a load test to verify before changing out the battery and hold off until fall to replace it.

You'll get it figured out. We have faith.

I would have expected nothing less.

F250 and F350 are among the most desired vehicles that are stolen. Older Chevies are also high on the list because they seem to be one of the easiest to pop the ignition.

If the floor jack won't fit, raise the rear higher till it will and then use the floor jack to compress the shock.